Adafruit Breadboard-friendly RGB Smart NeoPixel (Pack of 4)

This is the easiest way possible to add small, bright RGB pixels to your project. Adafruit took the same technology from their Flora NeoPixels and made them breadboard friendly, with two rows of 3 x 0.1" spaced header on each side for easy soldering, chaining and breadboarding. These ultra-bright LEDs have a constant-current driver cooked right into the LED package!

• The pixels are chainable - so you only need 1 pin/wire to control as many LEDs as you like.
• Full 24-bt colour ability with PWM taken care of by the controller chip
• Each pixel draws as much as 60mA (all three RGB LEDs on for full brightness white)
• An Arduino can drive up to 500 pixels at 30 FPS (it will run out of RAM after that).
• Using ribbon cable you can string these up to 6" apart (after that, you might get power droops and data corruption)
• The driver is constant current so its OK if your battery power changes or fluctuates a little.
• 5-9VDC power (can run at 3.5V but color will be dimmed), constant current 18.5mA per LED (~55mA max total per pixel)

Each order comes with 4 individually controllable pixels. In the photos above we show the pixels with headers soldered on, but the pixels do not come with any headers. Check out Adafruits Arduino library for some example code!